v2.2.15
=======

[microManager]

* Increased precision of the cursor's dX status. It matches the precision
  of the lower and upper ROI cursors.

* Increased precision of the ROI's OCR column. It matches the OCR in the
  main statistics panel.


v2.2.14
=======

[microManager]

* Fixed the ROI table to update the OCR whenever new statistics are available.

* Added precision to the energy value in the cursor status (top right above
  the spectrum). It now matches the precision of the Lower and Upper bounds in
  the ROI table.

* Fixed a bug where changing the GENSET dropdown would blank out out the
  display of the energy threshold if the threshold value was 0.

[Handel]

* Added board operation to get temperature.


v2.2.13
=======

[microManager]

* Changed microManager's main window to disable controls and display an 
  hourglass while refreshing the UI after the user selects a new peaking time 
  range.
  
* Enhanced the microDXP auto_detect routine by sending a Get Status command and 
  validating the response.

* Prevent startup errors by creating the ini file in the application directory 
  if no file can be found by looking in the registry and the application 
  directory.
  
* Add serial number to View -> Board info/Export to File

* Reset button state in case of a start run failure to allow retry.

* Apply bin scaling upon startup of microManager
  
[CHELSI]

* Fixed data logging file extension.

* Add error handling for invalid EvPerBin settings.

* Changed ROI definition, added additional ROI and threshold cursors, updated 
  CHELSI settings file format, added zone number to the PID log file.

* Add constraints to the cursor moving functions so that there's no 
  overlapping ROIs.

* Add number of presicion for dose computation.

* Allow negative PID threshold, removed visibility setting of the threhold 
  cursor.


v2.2.10
=======

[microManager]

* On startup microManager no longer checks if a firmware upgrade from
  v1 to v2 is necessary; there are no known v1 boards remaining.

* Fixed a bug where clicking the Get Baseline button just as a
  previous baseline read finished would cause a crash.

* Fixed the parset panel to prompt to save after changing only the
  threshold trigger and then selecting a new peaking time.

* Added the ability to restart microManager and refresh the UI from
  the board via the menu File, Restart.

* Fixed a bug that prevented microManager from starting after being
  installed on a system where National Instruments LabView 6 was
  already installed.

* Fixed the installer to add microManager to the applications listed
  in Windows Control Panel Add/Remove Programs.

* The uninstaller now deletes all subdirectories of the installation
  directory.

* Serial port configuration no longer uses hardware handshaking.


[Handel SDK]

* Fixed a bug where the wrong file pointer was being closed after an error
  opening a temporary firmware file.