• Introduction
  • Intended Audience
  • Conventions
  • Sample Code
    • hqsg-xmap
    • hqsg-xmap-preset
    • hqsg-xmap-mapping
  • Understanding Handel
    • Header Files
    • Error Handling
    • Thread Safety
    • .ini Files
      • [detector definitions]
      • [firmware definitions]
      • [default definitions]
      • [module definitions]
    • FDD Files
    • detChans
• MCA Data Acquisition
  • Initializing Handel
  • Configuring Data Acquisition
  • Run Control
  • Preset Runs
  • Cleanup
• Mapping Mode
  • Pixel Advance Modes
    • GATE
    • SYNC
    • Host Control
  • GATE/SYNC Signal Distribution
  • Using Mapping Mode: A Walkthrough
    • Enable mapping mode
    • Set the number of bins in the spectrum (MCA mode)
    • Set the number of ROIs and their bounds (SCA mode)
    • Set the variant (List-mode)
    • Set the total number of pixels to be acquired in this run (MCA/SCA mode)
    • Set the number of pixels per buffer
    • Configure pixel control
      • GATE
      • SYNC
      • HOST
    • Apply the settings
    • Get buffer length (MCA/SCA mode)
    • Start the run
    • Monitor the buffer status
    • Read full buffer (MCA/SCA mode)
    • Read full list-mode buffer (List-mode)
    • Signal that the read has completed
    • Wait for buffer ‘b’ to fill
    • Stop the run when all the pixels are collected
  • Mapping Tips
  • Parsing List-mode data buffers
• Acquisition Values
  • Filter
  • Gain
  • Detector
  • MCA Data Acquisition
  • SCA Data Acquisition
  • Mapping Mode
• Run Data
• Board Operations
• Legal
  • Licenses
    • Handel
    • Documentation
  • Disclaimer
  • Patents